Posts Tagged ‘woodturning projects’


Secure Cross Grain Box – 3D Print Meets Woodturning

This post is best viewed above here. In case of difficulty, it is also posted on YouTube and FaceBook. The wood for this project is plum burl salvaged by a wood carver. Unfortunately, he lost his job due to Covid and had to move. The wood could not go with him. This box has a […]

Read More...

Five Options For Woodturning Lathe Faceplates

This is best viewed with the control immediately above this. However, in case of difficulty, it is also posted on YouTube and FaceBook. I use a lot of faceplates in many different configurations. I prefer to start with an inexpensive block of poplar, thread it, and then adapt it to my project. When finished, I […]

Read More...

Live Edge Woodturning – Apple and Pear Box

This video is best viewed with the control above. In case of difficulty, it is also posted on YouTube (link) and FaceBook. Sometime ago after some annual pruning, I saved an apple limb. Shortly afterwards, I cut it into smaller sections and cored out the pith and center. Then left it to dry. Now, it […]

Read More...

Shocking End To Bandsaw Wood Preparation

Best video viewing is right here. But, in case of difficulty, the video is also posted on YouTube and FaceBook I accidentally cut my finger on my bandsaw but not where most of injury is. I did not see the risk near the power shutoff. Next to the off button is the return channel for […]

Read More...

Mousing Around With Woodturning – How To Capture A Mouse

This post is best viewed above here. In case of difficulty, it is also posted on YouTube and FaceBook. I want to turn a couple of mice refrigerator magnets for small gifts. A mouse is not a mouse without a long tail. In the past I would turn a mouse and then figure out how […]

Read More...

Woodturning Top With Spin Platform and Box

Best viewed by enabling the video above. In case of difficulty, this is also posted on YouTube and FaceBook. Why turn a top by itself. When spinning, a top is fun and colorful. But, when not spinning, it just lays around looking weird. Why not make the top the lid to a small box? Now […]

Read More...

Woodturning Eccentric Multi-Axis Candle

In case you cannot view this video right here, it is also posted on YouTube and FaceBook. What is the sense of turning an eccentric candlestick without a candle – especially and eccentric candle. The two candlesticks are turned with a twist for a unique look. For this candle, I did not want a twist. […]

Read More...

Revisit Eccentric Multi Axis Candlestick – With Jigs

In case you cannot view this post here, it is also posted on YouTube, and FaceBook. After last week’s experience with eccentric turning, aka scary turning, I needed to turn yet another. This time with a couple of improvements. One improvement was to have end plugs. Each plug has a tenon that fits the hole […]

Read More...

Woodturning Tall Eccentric – Multi-Axis – Candlestick

In case of difficulty viewing this post, it is also posted on YouTube and FaceBook. Eccentric turnings are both fun and scarey. One one hand they are unusual and interesting shapes. On the other hand, turning wood off-center is scarey. A lot of air gets sliced. This is based on Barbara Dill’s book. She has […]

Read More...

Woodturning Unique Two Piece Mushroom

In case of difficulty viewing this post, it is also posted on YouTube (Link) and FaceBook (link) Mushrooms are a favorite project for woodturners. In fact, I did a series of posts on mushrooms many years ago. One risk from those projects is the tight intersection between the underside of the cap and the top […]

Read More...