Posts Tagged ‘Utah’


Turning Oversize Ornament For Fund Raising Event

This video is best viewed here on this page. However, if there are difficulties, it is also posted on YouTube and FaceBook. Our club is turning oversize ornament for a Christmas tree to be auctioned in a fund raising event. By oversized, this ornament is twelve inches long and two inches diameter. It is walnut […]

Read More...

Turning Large Box Elder Burl Bowl

This post is also posted on YouTube and FaceBook. Where best? Right here! This bowl is turned from box elder burl, a beautifully figured but gnarly wood. A burl gives and takes away. It gives the beautiful figure and color; it takes away with defects and bark inclusions. Originally, the blank was over five inches […]

Read More...

Turning Enhanced Three Piece Goblet For Club Challenge

This video is best viewed here on this page. However, gremlins do attack occasionally, so it is also posted on YouTube and FaceBook. I did not want to turn a run of the mill goblet for our club challenge. To elevate my game, I decided to experiment with Celtic knot inspiration in the goblet bowl. […]

Read More...

What Not Round? How To Turn A Square Box

While it is best to view this video from this page, in case of difficulty, it is also posted on YouTube and FaceBook. Inspired by presentation at the AAW symposium, this project is a turned square box. Actually, it is a cube in 3D. The cube is walnut 3x3x3, finished with shellac and rattle-can lacquer. […]

Read More...

Turning Segmented Laminated Ornament Bells

In case of video difficulty, this is also posted on YouTube and FaceBook. But best right here! These bells are turned from a laminated block of maple, cherry, wenge, yellow heart, and padauk. Lamination involves gluing wood essentially side by side into a block. They wood was then segmented into a four segmented ring. Admittedly, […]

Read More...

Another Inexpensive Chucking Option To Supplement Jam Chucks

First, an addendum to the bouncy loops from last week. Latex tubing stretches more than I anticipated. I had to cut and re-glue to make several loops smaller. They need to be a tight fit. Check them with high speed rotation. Meanwhile, in preparation for another project that I have not turned previously, I make […]

Read More...

Inexpensive Hand Safety While Turning

This post is best viewed right here. However, in case of technical difficulties, it is also posted on YouTube and FaceBook. Occassionally, while working at the lathe with a chuck, my fingers go where they should not and get hit by the spinning metal. Since an ounce of protection is worth much more than a […]

Read More...

Turning A Bowl ??????

This video is best viewed right here on this page. However, in case of technical gremlins, it is also posted on YouTube and FaceBook. After acquiring a block of green oak, my choice were limited. Often, I would simply rip it in half and two two bowls – one from each half. However, this block […]

Read More...

Turning Small, Bark Edge Boxes – From Hazelnut Limbs

Unless there is a glitch, this page is best for viewing this post. If there is a glitch, this is also posted on YouTube and FaceBook. I pruned the wood for this project from my backyard several years ago. The limbs were suckers growing from the base. I kept many of them. Some have split […]

Read More...

A Tale Of Turning Two Bowls – Same Trunk – Opposite Look – Part 1

This video post is best viewed here on this page. However, in case of difficulty, it is also available on YouTube and FaceBook. I scored a section of a log sufficient for two bowls. Noticing that the bark is quite tight, I decided that one of them should be a natural or bark edge bowl […]

Read More...