Posts Tagged ‘safety’


Woodturning Essentials – Octagon Method For Perfect Spheres

This video is also posted on YouTube, Vimeo, and FaceBook. Best right here! My last video started with turning a perfect sphere then moving on to make it more artsy. However, I received many questions about how to turn a sphere. So, in this video, I’m slowing down and graphically illustrating the sphere turning process. […]

Read More...

Woodturning A Perfect Sphere Into A Strata-Sphere

This video is also available on YouTube, Vimeo, and FaceBook. Best right here. I am inspired by the great work I saw at the Utah Woodturning Symposium. My way to praise some of the work is to emulate it. Such is the case with this sphere inspired by Vivien Grandoullier from the Instant Gallery. Essentially, […]

Read More...

Dressing Up A Plain Small Mouth Bowl

This same video is available on YouTube, Vimeo, and FaceBook. But you are already right here! This project is a simple one. I had a block of wood laying around my shop. I think it came from the club wood raffle. It looked rather plain without a lot of figure. Perfect for a dyed bowl. […]

Read More...

What’s A Kuksa – Plus Lathe Mounted Belt Sander

This video is also available on YouTube, Vimeo, and FaceBook. Best right here at As Wood Turns. This month our club’s challenge was to turn a kuksa. What’s a kuksa? It is a drinking vessel from northern Scandinavia often carved from birch burl. However, I prefer woodturning over carving. My kuksa is from walnut. Since […]

Read More...

Green Woodturning – Two Halves Turn To More Than A Whole

This video is also posted on YouTube, Vimeo, and FaceBook. Best right here. This bowl has been in process for seven months – more if you count time from harvest to when I started roughing the wood. When I started turning, my plan was to experiment with a project cut in half and reassembled. My […]

Read More...

Woodturning Cottonwood Vase – No Last Word For The Worms

This video is also posted on YouTube, Vimeo, and FaceBook. Best right here! I was offered this wormy cottonwood at the club wood raffle. It looked pretty ugly and I could have swapped it for another piece of wood. But, I was curious whether I could turn something from it. It became a challenge piece […]

Read More...

Woodturning Bobbin For Wire Weaving Jewelry

This video is also posted on YouTube, Vimeo, and FaceBook. Best place? – Right here! My wife asked me to make a bobbin for her wire weaving. Of course, a small 2×3 inch bobbin should be a piece of cake. However, the bobbin requires that 5 cotter pins be set in a circle around the […]

Read More...

Woodturning Goblet With Captive Ring

This video is also posted on YouTube, Vimeo, and FaceBook. But you’re already here. I had yet to turn a captive ring. Similarly to any new dramatic technique, it seemed quite difficult and just a little impossible. So, when I received this wood from Brent Ross, it screamed out “I’m a goblet”. I’m special; I […]

Read More...

Woodturning An Offset Slat Bowl – Round 2 – Not This Way!

This video is also on YouTube, Vimeo, and FaceBook – but you’re already here so stick around. In round 1, I only glued the slats for this bowl to top and bottom waste blocks. That did not work so well. This time, I thought double stick tape would be just the thing to temporarily hold […]

Read More...

Woodturning: This Slab Bowl Nailed It

This video is also available on YouTube, Vimeo, and FaceBook. – Same video – best right here. Wood raffles can yield strange wood. Such is the case with this project. I received a slab of wood that I would usually throw away. This time, since it was already dry, I decided to attempt to turn […]

Read More...