A viewer suggesting making a leather burnisher. I was excited at the suggestion as it is another idea to exercise the eccentric faceplate system. Many would leave the blade as a cone or flatten it on a sander. To me, however, it was an opportunity to take the eccentric faceplate system for a spin. This […]
Read More...In this video, I’m going into greater detail on the faceplates and system used in making the doubly eccentric magic wand. The system consists of 2 faceplates, 4 brass pins, and some plastic countertop laminate. With the system, I can exactly index most eccentric spindle turnings that use a tail stock. Although I made these […]
Read More...In this video, I’m going another step beyond in eccentric turning. Building on a viewer suggestion to use masking tape to enable power transmission while backing off the pressure between tailstock and headstock. I made a pair of threaded faceplates in which I drilled holes to provide regular offsets. Corresponding holes would then be drilled […]
Read More...After the last video, I decided to go one step further and make an eccentric blade for another wand. By using multiple axes, the blade will be crooked, a special twist to please any wizard. This full sized 17″ long wand is made from walnut and red oak. It is finished with mineral oil and […]
Read More...This woodturning is made of apricot about 5″ tall and 1 1/2″ in diameter. The tree branches are painted with acrylic paint. The entire tree is finished with lacquer. The ornament has a handmade brass hanger. The branches were turned off axis. Three additional centers were marked on the base at 60 degree angles and about 3/8″ […]
Read More...