In this video, I’m going another step beyond in eccentric turning. Building on a viewer suggestion to use masking tape to enable power transmission while backing off the pressure between tailstock and headstock. I made a pair of threaded faceplates in which I drilled holes to provide regular offsets. Corresponding holes would then be drilled […]
Read More...After the last video, I decided to go one step further and make an eccentric blade for another wand. By using multiple axes, the blade will be crooked, a special twist to please any wizard. This full sized 17″ long wand is made from walnut and red oak. It is finished with mineral oil and […]
Read More...Harry Potter needs a new magic wand to withstand “he who must not be named“. This magic wand has the key to powerful magic – a Phoenix feather inside the handle. This full sized 17” long wand is made from walnut and red oak. It is finished with mineral oil and beeswax. It is a […]
Read More...After the Cascade Woodturners club asked me to do a demo, I needed to make a practice run. After the last whistle, a viewer suggesting making the whistle in a way that it could be tuned instead of relying solely on the depth of holes drilled in the cylinder. This whistle is tuned by inserting […]
Read More...To dispel my ball turning phobia forever, I decided to do a large, hollow ball. What’s different? Well, on a large ball, any irregular surface is more apparent. Even more is that I’m having to turn blind. I cannot check wall thickness as I work the wood — I have to rely on measurement taken […]
Read More...I am interested in multi-axis and off center turning. However, any change to the turning axis presents challenges and risks. This project, from hard maple, follows an example in “Woodturning Methods” by Mike Darlow. On the first axis, I turned the body, foot, and a mounting disk. Then I mounted a wood faceplate with a […]
Read More...In my last video I turned a couple of wood balls to overcome a long running phobia – a concern that I could ever turn a perfect wood sphere. But I did it. One requirement was to have a process that I described in that video. However, part of the process required a set of […]
Read More...One project during a week long woodturning class a few years ago was a wood ball using a jamb chuck. I failed miserably to get the ball smooth. It ended up very rough and out of round. With this failure, I feared being able to make a good ball. Since then, I’ve looked for a […]
Read More...On my lathe, I don’t think about cleaning the inside of the spindle or tail stock, but I should. Gunk can build up in the morse taper of these areas and throw off how well your drive and tail centers seat, center, and hold your work. The gunk can also cause damage to these tools. […]
Read More...In this video, I try my hand again to turn an eccentric goblet. I’ll turn the eccentric stem separately from the cup and the base just to keep things a little easier. The stem is 2×2″ maple about 6″ long. I started turning with the axis running almost corner to corner. Then as I finished […]
Read More...