While it is best to view this video from this page, in case of difficulty, it is also posted on YouTube and FaceBook. Inspired by presentation at the AAW symposium, this project is a turned square box. Actually, it is a cube in 3D. The cube is walnut 3x3x3, finished with shellac and rattle-can lacquer. […]
Read More...In case of video difficulty, this is also posted on YouTube and FaceBook. But best right here! These bells are turned from a laminated block of maple, cherry, wenge, yellow heart, and padauk. Lamination involves gluing wood essentially side by side into a block. They wood was then segmented into a four segmented ring. Admittedly, […]
Read More...First, an addendum to the bouncy loops from last week. Latex tubing stretches more than I anticipated. I had to cut and re-glue to make several loops smaller. They need to be a tight fit. Check them with high speed rotation. Meanwhile, in preparation for another project that I have not turned previously, I make […]
Read More...This post is best viewed right here. However, in case of technical difficulties, it is also posted on YouTube and FaceBook. Occassionally, while working at the lathe with a chuck, my fingers go where they should not and get hit by the spinning metal. Since an ounce of protection is worth much more than a […]
Read More...This video is best viewed right here on this page. However, in case of technical gremlins, it is also posted on YouTube and FaceBook. After acquiring a block of green oak, my choice were limited. Often, I would simply rip it in half and two two bowls – one from each half. However, this block […]
Read More...This video post is best viewed here on this page. However, in case of system difficulties, it is also posted on YouTube and FaceBook. Taking a break from larger project, in this video, I turn some simple pens from “tropical hardwoods”. The pen kit is a slimline. While I do not know the specific species […]
Read More...This video is best viewed right here. However, in case of difficulty such as a gremlin attach, it is also posted on YouTube and FaceBook. Most lathe tools come with handles. But why? Do we have to buy them with handles? Plus, if we are making our own handles, why not use the same handle. […]
Read More...This post is best viewed here on this page. However, if there are difficulties, it is also posted on YouTube and FaceBook. At club meeting, we had a great introduction to segmented turning. Ken, who presented went the extra (many) mile(s) to prepare segmented bowl kits with segments and a base for a bowl. I […]
Read More...