May also be viewed on YouTube. This bud vase is spalted birch harvested about a year ago. It is an eccentric turning on four axes: Main and offset by 3/8 inch at 120 degree intervals. A year ago, I rough turned it round and waxed it. It has been laying around my shop since then. […]
Read More...May also be viewed on YouTube. This project is my chance to practice what I learned from a demo by Eric Lofstrom at the Oregon Woodturning Symposium. The wood is cedar from my backyard tree. It is turned with four axes that created three curved facets. The primary axis is the normal center; the other […]
Read More...Also may be viewed on YouTube. This wood came from a fig tree in my front yard. It’s a small limb but had to go. I’ve never turned fig nor heard of anyone turning it. But why not try. Although it’s small, it is large enough for a simple tea light. I did not […]
Read More...After last week’s egg cup, Larry joked “why not an eccentric egg cup”. I took that as a challenge. This triple egg cup is turned from red cedar and finished with beeswax and mineral oil. The turning axis was shifted 1.25″ in three directions 120 degrees apart to turn the hollows for the eggs. It […]
Read More...My daughter sent me a pin from Pinterest for this little doodad. I’m not sure of its official name. But, it does a great job of holding the pages open while reading a book. Despite Kindle et al, real paper books are still with us. It’s a bit irritating at times to have to use […]
Read More...I am interested in multi-axis and off center turning. However, any change to the turning axis presents challenges and risks. This project, from hard maple, follows an example in “Woodturning Methods” by Mike Darlow. On the first axis, I turned the body, foot, and a mounting disk. Then I mounted a wood faceplate with a […]
Read More...