I chose to turn this cactus shaped necklace holder as I’m “on-location” in Arizona. To me, it is an exercise in slicing a woodturning and re-gluing it for a different effect. At the same time, since I don’t have access to a drill press, I used my lathe to drill holes in the side for […]
Read More...For an beautiful jewelry item, how about this segmented wood bolo tie? The medallion is made from 24 segments of walnut and maple with a walnut center and walnut bolo finial tips. The renewable finish is beeswax and mineral oil. The design symbolizes a old west wagon wheel. The metal clasp and cord is available […]
Read More...In my last video I turned a segmented bracelet using my new home made bracelet chuck. It is an expansion chuck using basic engineering principles with lathe components. It uses 2 tapered end plugs, 8 tapered side slats, 2 automotive band clamps, 4 latex tubing rings, and a little duct tape. One end plug is […]
Read More...Last summer, I turned some wood bracelets for my granddaughters. Afterwards, a viewer send in a question about how to turn the outside of the bracelet without flipping the workpiece over. With that in mind, I designed an expansion chuck on which to turn bracelets. With the chuck, I can now turn bracelets more easily. […]
Read More...With the pending visit from my grandchildren, I decided to make a bracelet or bangle for each girl. In the last video, I made the first set of three. But with six granddaughters, 3 bracelets is not enough. I needed three more. With three under my belt, I changed them a little bit. In the […]
Read More...Several years ago, I had a bright idea to make wooden ties. I made several which turned out very nice except they were not very comfortable to wear. They only bent in one direction. I did not make any more beyond the first batch but still had a lot of wood milled out. Now I’m […]
Read More...