Woodturning Multi-Axis Single Piece Wood Scoop
by Alan Stratton on Friday, July 1st, 2022 | 2 Comments
This post is best viewed here on this page. In case of difficulty, it is also posted on YouTube and FaceBook.
After a friend called me with a question about turning a scoop, that prompted me to review my past videos where I turned scoops. It has been a while. So it is time to turn some again to ensure my skills are still current.
This is from pear, 2 inches diameter and 4 inches long finished with beeswax(25%) and mineral oil(75%) mix. Handle offset from primary axis.
Steps:
- Cut a tenon;
- Hollow the scoop portion;
- Turn a plug to fit;
- Turn the exterior;
- Using plug, offset the turning axis about 1/4″
- Turn the handle;
- Saw the scoop portion;
- Sand and finish remaining rough edges.
Enjoy!
Neat idea in using a plug, I have always turned the handle & than hollowed the the other end. Thanks for the hint!
No problem – Enjoy
Alan